X-banner stand
The X-banner stand is a light display whose cross frame tensions the print from its four corners. It goes up in a few moves, stands on its own and takes little room once packed away, which makes it the back-up display of trade shows, open days and in-store promotions. Print and frame can be ordered together or on their own.
- Two sizes: 60x160 and 80x180 cm
- Standard material or M1 fire-rated material
- Frame with print, print only, or frame only
Configure my product
Loading options…
Templates & instructions
Technical sheet
- Resolution
- 300 DPI
- Colours
- CMYK
- Bleed
- 2 mm
- Safety margin
- 4 mm
Which material for your X-banner stand?
Two printed materials are offered. The standard one covers most uses: a promotion, a reception area, a presentation room. The M1 fire-rated material answers venues that require a fire classification for decorative elements, which exhibition centres and some public buildings ask for as a matter of course. Check the event rules before choosing, since this is a constraint of the venue rather than of your design.
Available sizes
The 60x160 cm is the discreet one. It sits behind a counter, in a corridor or beside a demonstration table without swallowing the space. The 80x180 cm is the stand-entrance format: wider and taller, it carries a message that reads from the aisle. Used in pairs, one either side of an entrance, they frame a space cleanly.
Frame, print or replacement
The order splits three ways. Frame and print for a first fit-out, print only when you keep the cross frame from one campaign to the next, and a replacement frame when one has travelled too much. Both display families are gathered in the banner section, and the versions of this model in the X-banner section.
Preparing your file
300 DPI, CMYK, 2 mm bleed and a 4 mm safety margin. The four corners take the tensioning eyelets, so keep text and logos away from them. The lower part of the visual is often hidden by visitors: use it for a background colour rather than for information that matters.
2M Numérique alongside you
We print your X-banner stands in our workshop at Manciet, in the Gers, made in Occitanie throughout, in the spirit of our responsible approach. For a series, several visuals or a complete set-up, ask us for a tailored quote.
Made here
94 % of our orders were produced in-house in 2024-2025, and 100 % in France. Our workshop is in Manciet, in the Gers, near Nogaro — recent machinery, local workshops. Less transport, faster turnaround.
Committed suppliers
We source our materials from regional partners who share our standards. Our main textile supplier is a French manufacturer whose site in Hagetmau, in the neighbouring Landes, supplies us through a short circuit — EcoVadis Platinum 2024, organic cotton and recycled textile ranges certified GOTS and GRS. Our paper comes from sustainably managed forests.
Less waste
PVC offcuts, paper and substrates are sorted and recovered; our adhesive films are available in recycled PVC. Nesting and imposition of files cut offcuts down: we print the right quantity. And low-impact inks, for prints that last.
A person, not a form
A close-knit team, from the first idea to the finished product. Every project, large or small, gets the same care. A question about your file? +33 5 33 13 02 01.
You might also like
L-Banner stand
From €33.60