Bollard cover
The bollard cover wraps a post, a bollard or a furniture leg in printed board. Slipped over the existing item, it turns dead hardware into a display without drilling or fixing anything. Shops use it at the end of an aisle, beside the entrance, on an exhibition stand or for the length of a seasonal promotion.
- Two sizes: 50 x 11 x 160 cm and 50 x 06 x 160 cm (W x D x H)
- E-flute board with a white liner
- Light structure, assembled on site, moved without tools
Configure my product
Loading options…
Templates & instructions
Technical sheet
- Resolution
- 300 DPI
- Colours
- CMYK
- Bleed
- 2 mm
- Safety margin
- 4 mm
Which board is used for the bollard cover?
One material, chosen for the job: E-flute corrugated board with a white liner. E-flute is a fine flute, so the surface stays even, without the ripples a coarse flute leaves under printing. The white liner gives a neutral base: colours come out clean, solids stay uniform and small type holds together. Thin as it is, the board is rigid once folded into shape, yet light enough for one person to move the cover from one aisle to another.
Available sizes
Both versions stand 160 cm tall and 50 cm wide, which puts the message at eye level for a standing customer. They differ in depth. At 50 x 11 x 160 cm there is room for a bollard, a totem or a substantial post. The flatter 50 x 06 x 160 cm version is meant for slim items: an upright, a panel edge, a shopfront border. Measure the section you need to cover before deciding, since depth is the one dimension you cannot make up for later.
Installation and uses
The cover goes up by hand and comes down just as quickly, which suits campaigns that change: sales, a launch, a local festival. It hides an unattractive fixture and puts it to work at the same time. Other in-store displays are gathered in our point-of-sale section.
Preparing your artwork
300 DPI, CMYK, 2 mm of bleed and a 4 mm safety margin. Work on the flat plan and mark the vertical edges: a logo placed on a corner breaks in two. The lower part is often hidden by a display unit or by passing shoppers, so keep the important message between 80 and 150 cm from the floor.
2M Numérique at your side
This bollard cover is cut and printed in our workshop in Manciet, in the Gers, south-west France: 100% Made In Occitanie, a short supply chain described in our responsible approach. Send us the dimensions of your posts and we will confirm which size fits.
Made here
94 % of our orders were produced in-house in 2024-2025, and 100 % in France. Our workshop is in Manciet, in the Gers, near Nogaro — recent machinery, local workshops. Less transport, faster turnaround.
Committed suppliers
We source our materials from regional partners who share our standards. Our main textile supplier is a French manufacturer whose site in Hagetmau, in the neighbouring Landes, supplies us through a short circuit — EcoVadis Platinum 2024, organic cotton and recycled textile ranges certified GOTS and GRS. Our paper comes from sustainably managed forests.
Less waste
PVC offcuts, paper and substrates are sorted and recovered; our adhesive films are available in recycled PVC. Nesting and imposition of files cut offcuts down: we print the right quantity. And low-impact inks, for prints that last.
A person, not a form
A close-knit team, from the first idea to the finished product. Every project, large or small, gets the same care. A question about your file? +33 5 33 13 02 01.
You might also like
Cardboard cube totem
From €52.80
In the same category
Pavement sign
From €104.40
Tension fabric frame
From €51.60
Cardboard cube
From €22.80
Counter display stand
From €570.00